![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
|||||||||||||||
![]() |
![]() |
||||||||||||||
|
|
![]() ![]() |
||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
||||
|
|
|
|
|
|
|
|
|||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
||
|
Cat. 5 VGA Extenders |
||
|
1T-VGA-CAT consists of a transmitter and receiver unit capable of encoding and decoding of up to 1280x1024 VGA resolution signal into a bit stream suitable for remote viewing using a single, dedicated CAT 5 grade network cable. Transmission distances of 590 feet (180m) are possible with this device. One transmit/receive pair will provide an image to a single remotely located VGA monitor or projector. 1T-VGA-CAT-XL has the same features, resolution, encode and decode capabilities of the 1T-VGA-CAT but doubles the range to 1000 feet (300m). VGA loop-thru is provided on the 1T-VGA-CAT-XL Transmitter. 1T-VGAST-CAT-XL is the same as the 1T-VGA-CAT-XL but adds the ability to include either PC audio or external microphone audio in the CAT.5 signal. 1T-VGA4-CAT-TXL and 1T-VGA8-CAT-TXL encode a VGA signal of up to 1280x1024 resolution and feed 4 or 8 CAT 5 cables respectively over distances of up to 1000 feet (300m). VGA loop-thru is provided with these units. 1T-VGA-CAT-RXL decodes signals received via CAT 5 cables from the 1T-VGA4-CAT-TXL or 1T-VGA8-CAT-TXL transmitter. A dedicated CAT 5 cable plus a dedicated 1T-VGA-CAT-RXL receive unit is required for each remotely located VGA display device. Equalization and gain controls are provided for each receiver. |
||
Click the image for a larger view ...
|
|
|||||||||||||||||||||||||||||
